TM 9-2320-260-20
4-48. BATTERY CABLES AND CLAMPS REPLACEMENT (Contd)
f. Accessory Cable Installation
1.
Connect accessory cable (11) to lead (1).
2.
Route accessory cable (11) behind engine (2), over transmission top cover (8), and through frame (7).
Install accessory (11) cable on terminal clamp (31) with nut (32).
3.
4.
Install battery cable (20) on two terminal clamps (23) with screws (24) and nuts (21).
Install battery cable (17) on two terminal clamps (18) with screws (19) and nuts (16) and (28).
5.
Apply light coat of GAA grease to two terminal clamps (18) and (23).
6.
Install two terminal clamps (18) and (23) on battery posts (35), (33), (34), and (30). Tighten two nuts
7.
(22) and (27) and screws (25) and (26).
Install accessory cable (11), positive cable (6), and negative cable (5) on engine (2) with clamp (9) and
8.
new screw-assembled lockwasher (10).
Install accessory cable (11), positive cable (6), and negative cable (5) on transmission top cover (8)
9.
with two clamps (4) and new screw-assembled lockwashers (3).
10.
Place grommet (38) around positive cable (6) and accessory cable (11) and install grommet (38) on
frame (7).
11.
Install clamp (36) on positive cable (6) and accessory cable (11) with screw (29) and nut (37).
g. Positive Cable Installation
Install positive cables (6) and (13) on starter solenoid (14) with new lockwasher (12) and nut (15).
1.
2.
Route positive cable (6) behind engine (2), over transmission top cover (8), and through hole in
frame (7).
Install positive cable (6), negative cable (5), and accessory cable (11) on engine (2) with clamp (9) and
3.
new screw-assembled lockwasher (10).
4.
Install positive cable (6), negative cable (5), accessory cable (11) on transmission top cover (8) with
two clamps (4) and new screw-assembled lockwashers (3).
Install positive cables (6) and (39) on terminal clamp (43) with screw (41) and nut (40).
5.
Apply light coat of GAA grease to terminal clamp (43).
6.
Install terminal clamp (43) on battery post (45) and tighten nut (44) and screw (42).
7.
Install positive cable (39) on terminal clamp (48) with screw (46) and nut (51).
8.
Apply light coat of GM grease to terminal clamp (48).
9.
10.
Install terminal clamp (48) on battery post (49) and tighten nut (50) and screw (47).
11.
Place grommet (38) around positive (6) and accessory cable (11) and install
grommet (38) on frame (7).
12.
Install clamp (36) on positive cable (6) and accessory cable (11) with screw (29) and nut (37).
4-96
