TM 9-2320-260-20
4-48. BATTERY CABLES AND CLAMPS REPLACEMENT (Contd)
h. Ground and Negative Cable Installation
1.
Install ground strap (14), ground cable (13), and negative cable (4) on starter (12) with new
lockwasher (15) and nut (16).
2.
Route negative cable (4) behind engine (1), over transmission top cover (9), and through grommet (5)
on frame (8).
Install negative cable (4), positive cable (6), and accessory cable (7) on engine (1) with clamp (10) and
3.
new screw-assembled lockwasher (11).
Install negative cable (4), positive cable (6), and accessory cable (7) on transmission top cover (9)
4.
with two clamps (2) and new screw-assembled lockwashers (3).
Install negative cable (4), ground cable (22), and negative slave cable (21) on frame (8) with two new
5.
lockwashers (18), screw (17), and new locknut (23).
Install negative cable (4) on frame (8) with clamp (26), screw (27), and new locknut (24).
6.
Install negative cable (29) and ground cable (22) on terminal clamp (19) with screw (33) and nut (20).
7.
Apply light coat of GAA grease to terminal clamp (19).
8.
Install terminal clamp (19) on battery post (31) and tighten nut (32) and screw (30).
9.
10.
Install ground cable (29) on screw (25) with nut (28).
