TM 9-2320-260-20
I
THIS TASK COVERS:
g. Removal (M819)
a. Removal (M818, M820, M820A1, M820A2)
h. Installation (M819)
b. Installation (M818, M820, M820A1, M820A2)
i. Removal (M816)
c. Removal (M817)
j. Installation (M816)
d. Installation (M817)
k. Removal (M815)
e. Removal (M813, M813A1, M814)
l. Installation (M815)
f. Installation (M813, M813A1, M814)
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
All
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Twelve screw-assembled lockwashers
Parking brake set (TM 9-2320-260-10).
Eighteen lockwashers
Battery ground cable disconnected (para. 4-48).
Thirteen locknuts
NOTE
Tag all wires for installation.
a. Removal (M818, M820, M820A1, M820A2)
1.
Remove four screws (7) and cover (6) from bracket (11).
2. Disconnect four leads (12) from wires (10).
3. Remove two screw-assembled lockwashers (8) and housing (13) from bracket (11). Discard screw-
assembled lockwashers (8).
4. Remove locknut (16), screw (3), nut (9), screw (4), two lockwashers (5), and bracket (11) from
brace (2). Discard locknut (16) and lockwashers (5).
5. Remove two nuts (14), screws (15), and brace (2) from frame (1).
b. Installation (M818, M820, M820A1, M820A2)
1. Install brace (2) on frame (1) with two screws (15) and nuts (14).
2. Install bracket (11) on brace (2) with two new lockwashers (5), screw (4), nut (9), screw (3), and new
locknut (16).
3. Connect four leads (12) through hole in bracket (11) to wires (10).
4. Install housing (13) on bracket (11) with two new screw-assembled lockwashers (8).
5. Install cover (6) on bracket (11) with four screws (7).
4-82
