TM 9-2320-366-20-5
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Gasket (Item 29, Appendix G)
Filter Element, Fluid (Item 16, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
a. Removal.
(1) Remove six screws (1) and washers (2) from filter cover
(3).
(2) Remove filter cover (3) and gasket (4) from hydraulic
tank (5). Discard gasket.
NOTE
Some filters were originally equipped with a
preformed packing. If equipped, remove and
discard preformed packing.
(3) Remove filter (6) from filter cover (3). Discard filter.
b. Installation.
NOTE
If preformed packing is included with
replacement filter kit, discard preformed
packing.
(1) Install filter (6) on filter cover (3).
(2) Position gasket (4) and filter cover (3) on hydraulic tank
(5) with six washers (2) and screws (1).
(3) Tighten six screws (1) to 23-25 lb-ft (31-34 Nm).
End of Task.
