TM 9-2320-366-20-5
This task covers:
a. Cab Lift
b. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Cap and Plug Set (Item 14, Appendix D)
Nut, Self-locking (4) (Item 168, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Personnel Required
Goggles, Industrial (Item 15, Appendix C)
(2)
Gloves, Rubber (Item 13, Appendix C)
Pan, Drain (Item 24, Appendix C)
Cab Support Tool (Item E-4, Appendix E)
a. Cab Lift.
CAUTION
Perform this task in the event that the air/
hydraulic power unit and the back-up hydraulic
pump are inoperative at the same time.
(1) Place drain pan under hydraulic hose (1).
WARNING
Hydraulic fluid (MIL-H-5606) is TOXIC. Wear
protective goggles and gloves; use only in
well-ventilated area; avoid contact with skin,
eyes, and clothes. Skin and clothing that
come in contact with hydraulic oil should be
washed immediately. Saturated clothing
should be removed immediately. Failure to
comply may result in injury to personnel.
CAUTION
Cap or plug hose and connection point to
prevent contamination of hydraulic system.
Failure to comply may result in damage to
equipment.
(2) Disconnect hydraulic hose (1) from 90-degree fitting (2).
(3) Remove four self-locking nuts (3), washers (4), screws
(5), from cab hydraulic latch (6) and cab support
assembly (7). Discard self-locking nuts.
