TM 9-2320-366-20-5
This task covers:
a. Removal
c. Adjustment
b. Installation
d. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Cap and Plug Set (Item 14, Appendix D)
Cab raised (TM 9-2320-366-10-1).
Hydraulic Fluid A (Item 25, Appendix D)
Nut, Self-Locking (4) (Item 168, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Pan, Drain (Item 24, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Gloves, Rubber (Item 13, Appendix C)
a. Removal.
(1) Position drain pan under hydraulic hose (1).
WARNING
Hydraulic fluid (MIL-H-5606) is TOXIC.
Wear protective goggles and gloves; use
only in well ventilated area; avoid
contact with skin, eyes, and clothes.
Skin and clothing that come in contact
with hydraulic oil should be washed
immediately. Saturated clothing should
be removed immediately. Failure to
comply may result in injury to
personnel.
CAUTION
Cap or plug hydraulic hose and connection
point to prevent contamination of hydraulic
system. Failure to comply may result in
damage to equipment.
(2) Disconnect hydraulic hose (1) from 90-degree fitting
(2).
(3) Remove four self-locking nuts (3), washers (4), screws
(5), and hydraulic latch (6) from cab support assembly
(7). Discard self-locking nuts.
(4) Remove 90-degree fitting (2) from hydraulic latch (6).
Change 1
