TM 9-2320-366-20-5
Section II. MAINTENANCE PROCEDURES
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Dispenser, Pressure Sensitive Adhesive Tape
(Item 20, Appendix D)
Cap and Plug Set (Item 14, Appendix D)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Hydraulic Fluid A (Item 25, Appendix D)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Packing, Preformed (2) (Item 186, Appendix G)
Gloves, Rubber (Item 13, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
a. Removal.
(1) Remove two screws (1), washers (2), and cover (3) from
back-up hydraulic pump (4).
WARNING
Hydraulic fluid (MIL-L-5606) is TOXIC.
Wear protective goggles and gloves; use
only in well ventilated area; avoid contact
with skin, eyes, and clothes. Skin and
clothing that come in contact with
hydraulic oil should be washed
immediately. Saturated clothing should
be removed immediately. Failure to
comply may result in injury to personnel.
CAUTION
Cap or plug hydraulic hoses and connection
points to prevent contamination of hydraulic
system. Failure to comply may result in
damage to equipment.
NOTE
Tag hoses and connection points prior to
disconnecting.
(2) Disconnect two hydraulic hoses (5) from 90-degree
fittings (6).
