TM 9-2320-366-20-5
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning/Inspection
f. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Dispenser, Pressure Sensitive Adhesive Tape (Item
Hydraulic tank supply and return valves closed (TM
20, Appendix D)
9-2320-366-10-2).
Cap and Plug Set (Item 14, Appendix D)
Solvent, Dry Cleaning (Item 65, Appendix D)
Rag, Wiping (Item 50, Appendix D)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Parts Kit, Hydraulic Pump (Item 219, Appendix G)
Gloves, Rubber (Item 13, Appendix C)
Lockwasher (4) (Item 96, Appendix G)
Goggles, Industrial (Item 15, Appendix C)
Packing, Preformed (4) (Item 187, Appendix G)
Gasket and Preformed Packing Kit (Item 43,
a. Removal.
(1) Position drain pan under hand pump (1).
CAUTION
Cap or plug hydraulic tubes to prevent
contamination of hydraulic system. Failure to
comply may result in damage to equipment.
NOTE
Tag tubes and connection points prior to
disconnecting.
(2) Disconnect two hydraulic tubes (2) from 90-degree
fittings (3).
(3) Remove four screws (4), lockwashers (5), washer (6)
and hand pump (1) from bracket (7).
Discard
