TM 9-2320-366-20-5
(4) Insert wedge (5) in cable (1), loop and pull cable and
wedge into sleeve.
(5) Drive wedge (5) and cable (1) into sleeve (4) until
seated.
(6) Start engine (TM 9-2320-366-10-1).
WARNING
Never let moving cable slide through
hands, even when wearing gloves. A
broken wire could cut through gloves.
Failure to comply may result in injury to
personnel.
NOTE
After one complete layer of cable is on drum,
provide tension on cable by physically pulling
on cable so that cable spools on tightly.
Leave enough cable unspooled to allow
installation of hook block.
(7) Reel in cable onto drum (TM 9-2320-366-10-1).
c. Follow-On Maintenance.
(1) Install hook block assembly (para 17-4).
(2) Stow MHC (TM 9-2320-366-10-1).
End of Task.
