TM 9-2320-366-20-5
Section II. MAINTENANCE PROCEDURES
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools
Hook block assembly removed (para 17-4).
Tool Kit, Genl Mech (Item 46, Appendix C)
Hoist cable fully extended (TM 9-2320-366-10-1).
Gloves, Welder's (Item 14, Appendix C)
Engine shut down (TM 9-2320-366-10-1).
WARNING
Cable can become frayed or contain broken
wires. Wear heavy leather-palmed gloves
when handling cable. Frayed or broken
wires can injure hands. Failure to comply
may result in injury to personnel.
a. Removal.
(1) Drive cable wedge (1) and cable (2) out of sleeve (3).
(2) Pull cable (2) from sleeve (3).
(3) Remove cable (2) from drum (4).
b. Installation.
(1) Route cable (1) over and around drum (2).
(2) Insert cable (1) through slot (3) in side of drum (2).
(3) Route cable (1) up through sleeve (4) and back down
into sleeve, making a loop.
