TM 9-2320-366-20-4
14-12. PINTLE HOOK REPLACEMENT (CONT)
b. Installation.
NOTE
All pintle hooks are installed the same way.
M1083/M1093 shown.
(1) Position support (1) on rear crossmember (2) with
four screws (3) and self-locking nuts (4).
(2) Tighten four self-locking nuts (4) to 195-239 lb-ft
(265-325 Nm).
(3) Apply coat of grease to shaft of pintle hook (5).
WARNING
Pintle hook weighs approximately 65 lbs
(30 kgs). Attach a suitable lifting device
prior to installation. Failure to comply
may result in injury to personnel or
damage to equipment.
(4) Install pintle hook (5) in rear crossmember (2)
with washer (6) and nut (7).
CAUTION
Clearance between washer and support must
be 0.003-0.017 in. (0.007-0.043 cm). Failure
to comply may result in damage to
equipment.
(5) Adjust nut (7) until clearance is 0.003-0.017 in.
(0.007-0.043 cm) with alignment holes lined up
between nut and pintle hook (5).
(6) Install cotter pin (8) in nut (7).
c. Follow-On Maintenance.
Lubricate pintle hook (TM 9-2320-366-20).
End of Task.
Change 2
