TM 9-2320-366-20-4
This task covers:
a. Removal
c.
Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1)
Nut, Self-locking (4) (Item 161, Appendix G)
Pin, Cotter (Item 236.1, Appendix G)
Grease, Automotive and Artillery (GAA) (Item
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
22, Appendix D)
Goggles, Industrial (Item 15, Appendix C)
Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C)
Personnel Required
Wrench Set, Socket (Item 50, Appendix C)
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
All pintle hooks are removed the same way.
M1083/M1093 shown.
(1) Remove cotter pin (1) from nut (2). Discard cotter
pin.
(2) Remove nut (2) and washer (3) from pintle hook
(4).
WARNING
Pintle hook weighs approximately 65 lbs
(30 kgs). Attach a suitable lifting device
prior to removal. Failure to comply may
result in injury to personnel or damage to
equipment.
(3) Remove pintle hook (4) from rear crossmember (5).
(4) Remove four self-locking nuts (6), screws (7), and
support (8) from rear crossmember (5). Discard
self-locking nuts.
Change 2
