TM 9-2320-366-20-4
13-7. POWER STEERING HOSES AND TUBE REPLACEMENT (CONT)
CAUTION
Clamp tongue must be started in clamp
groove. Failure to comply may result in
damage to equipment.
(4) Position clamp (5) on return hose (2).
(5) Install return hose (2) on power steering reservoir
(9).
(6) Engage as many clamp tabs (7) as possible in tab
windows (8) allowing little or no play between
clamp (5) and return hose (2).
(7) Tighten clamp (5) to 8-9 lb-in. (1 Nm).
NOTE
Minimum allowable gap on clamp is 0.2
in. (0.5 cm). If gap is less than 0.2 in.
(0.5 cm), remove and re-install clamp.
(8) Measure gap on clamp (5).
13-18
Change 2
