TM 9-2320-366-20-4
11-30. LOW PRESSURE TRANSMITTER TWO-WAY CHECK VALVE REPLACEMENT
(CONT)
(9) Connect air hose (11) to 90-degree fitting (4).
(10) Connect air hose (12) to fitting (1).
(11) Connect two air hoses (13) to run tee fitting (2).
(12) Install terminal lugs TL202 (14) and TL201 (15) on low
pressure transmitter (6) with two lockwashers (16) and
nuts (17).
WARNING
Adhesives, solvents, and sealing com-
pounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water. Failure
to comply may result in injury to
personnel.
(13) Apply adhesive to terminal lugs TL202 (14) and TL201
(15).
NOTE
Perform steps (14) and (15) on vehicle serial
number 7448 and higher and vehicle serial
numbers 0001 through 7447 that have
previously had front lights cable assembly
replaced.
(14) Install boot (15.1) on low pressure transmitter (6).
(15) Apply antiseize compound to holes TLR and TTR and
around edges of boot (15.1).
11-184
Change 1
