TM 9-2320-366-20-4
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Dispenser, Pressure Sensitive Adhesive Tape
Dump body raised (TM 9-2320-366-10-1).
(Item 21, Appendix D)
Cap and Plug Set (Item 15, Appendix D)
Tie, Cable, Plastic (Item 69, Appendix D)
Tools and Special Tools
Goggles, Industrial (Item 15, Appendix C)
Nut, Self-locking (7) (Item 150, Appendix G)
Pan, Drain (Item 24, Appendix C)
Packing, Preformed (2) (Item 178.1, Appendix G)
Wrench, Torque 0-200 lb-in. (Item 59, Appendix C)
Antiseize Compound (Item 58, Appendix D)
Tool Kit, Genl Mech (Item 46, Appendix C)
Nut, Self-Locking (4) (Item 162, Appendix G)
Crowfoot Attachment, Socket Wrench (Item 12.1,
Gasket (Item 29.3, Appendix G)
Packing, Preformed (4) (Item 179, Appendix G)
Socket Set, Socket Wrench (Item 34, Appendix C)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Personnel Required
Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C)
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the possibility
of falling debris. Failure to comply may
result in injury to personnel.
Ensure exhaust system is cool before
preforming maintenance. Failure to comply
may result in injury to personnel.
a. Removal.
CAUTION
Cap or plug hoses when disconnecting to
prevent contamination of transmission oil.
Failure to comply may result in damage to
equipment.
NOTE
Tag hoses and connection points prior to
disconnecting.
Step (1) requires the aid of an assistant.
(1) Remove four self-locking nuts (1), bolts (2), and lower
front support crossmember (3) from vehicle. Discard
self-locking nuts.
Change 1
