TM 9-2320-366-20-4
This task covers:
a. Removal (S/N 0001-7167)
d. Installation (S/N 7162 and higher)
b. Installation (S/N 0001-7161)
e. Follow-On Maintenance
c. Removal (S/N 7162 and higher)
INITIAL SETUP
Equipment Conditions
Materials/Parts
Batteries disconnected (para 7-57).
Dispenser, Pressure Sensitive Adhesive Tape
(Item 20, Appendix D)
Cap and Plug Set (Item 14, Appendix D)
Tools and Special Tools
Goggles, Industrial (Item 15, Appendix C)
Ties, Cable, Plastic (Item 69, Appendix D)
Pan, Drain (Item 24, Appendix C)
Nut, Self-Locking (2) (Item 167, Appendix G)
Tool Kit, Genl Mech (Item 46, Appendix C)
Nut, Self-Locking (2) (Item 154, Appendix G)
Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C)
Nut, Self-Locking (2) (Item 152, Appendix G)
Socket Set, Socket Wrench (Item 34, Appendix C)
Washer, Spring (2) (Item 291, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Packing, Preformed (2) (Item 178.1, Appendix
Crowfoot Attachment, Socket Wrench (Item 12.1,
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the possibility
of falling debris. Failure to comply may
result in injury to personnel.
Ensure exhaust system is cool before
performing maintenance. Failure to comply
may result in injury to personnel.
NOTE
Vehicle serial numbers 0001-7161 may have
transmission oil cooler tubes installed.
Vehicle serial numbers 7162 and higher will
have transmission oil cooler hoses installed.
a. Removal (S/N 0001-7161).
(1) Remove two self-locking nuts (1), washers (2), and
screws (3) from heat shield (4). Discard self-locking
nuts.
(2) Remove two self-locking nuts (5), spring washers (6),
washers (7), screws (8), washers (9), and heat shield (4)
from transmission auxiliary oil cooler (10). Discard self-
locking nuts and spring washers.
Change 1
