TM 9-2320-366-20-4
b. Installation.
NOTE
Perform steps (1) through (12) on vehicle
serial numbers 0001 through 7447 that have
not previously had front lights cable assembly
replaced.
(1) Drill two holes 0.05-0.07 in. (0.127-0.178 cm) in TLR and
TTR areas of boot (1).
(2) Cut two pieces of insulation sleeving (2) 1.57 in. (4 cm).
(3) Position two insulation sleevings (2) on wires 3024 (3)
and 1616 (4).
(4) Route wire 3024 (3) through hole TLR in boot (1).
(5) Route wire 1616 (4) through hole TTR in boot (1).
(6) Cut two pieces of insulation sleeving (5) 0.78 in. (2 cm).
(7) Position two insulation sleevings (5) on wires 3024 (3)
and 1616 (4).
(8) Remove approximately 1/4 in. (0.6 cm) of insulation from
wires 3024 (3) and 1616 (4).
(9) Install terminal lug TL201 (6) on wire 3024 (3).
(10) Install terminal lug TL202 (7) on wire 1616 (4).
(11) Position two insulation sleevings (5) on terminal lugs
TL201 (6) and TL202 (7).
(12) Shrink two insulation sleevings (2 and 5) on TL201 (6)
and TL202 (7).
Change 1
7-701
