TM 9-2320-272-24-4
5-79. CEILING FILLER AND SIDE PANELS REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
EQUIPMENT CONDITION
l Parking brake set (TM 9-2320-272-10).
M934/A1/A2
Inside telephone jacks (ceiling) removed
l
TOOLS
(para. 3-374).
General mechanic's tool kit (Appendix E, Item 1)
Blackout light switches and receptacles removed
l
(para. 3-373).
MATERIALS/PARTS
Ceiling deflectors and registers removed
l
Adhesive (Appendix C, Item 7)
Blackout and emergency light fixtures removed
Primer (Appendix C, Item 57)
l
(para. 3-372).
PERSONNEL REQUIRED
Fluorescent light fixtures removed (para. 4-168).
l
l Rear splice plate removed (para. 5-84).
TWO
SPECIAL ENVIRONMENTAL CONDITIONS
REFERENCES (TM)
TM 9-2320-272-10
Vehicle must be on a level surface.
TM 9-2320-272-24P
NOTE
Left and right ceiling filler and side panels are replaced the same
way. This procedure covers the left side.
a. Removal
1.
Remove thirty screws (9) and side panel (8) from lintel (6), air ducts (5) and (7), and filler panel (1).
2.
Remove seven screws (10) and filler panel (1) from filler angles (2) and (3) and transition (4).
3.
Remove forty-four screws (14) and side panel (15) from lintel (6), rear header (13), and air ducts (11)
and (12).
NOTE
Insulate areas of dissimilar metal-to-metal contact with zinc
l
chromate primer.
Apply adhesive to both rubber and metal surfaces.
l
Insulate entire structure with fibrous glass felt insulation.
l
1.
Install side panel (15) on lintel (6), rear header (13), and air ducts (12) and (11) with forty-four
screws (14).
2.
Install tiller panel (1) on filler angles (3) and (2) and transition (4) with seven screws (10).
3.
Install side panel (8) on lintel (6), air ducts (7) and (5), and filler panel (1) with thirty screws (9).
5-532
