TM 9-2320-272-24-4
5-77. HINGED ROOF MAINTENANCE
THIS TASK COVERS:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning and Inspection
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M93/A1/A2
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
General mechanic's tool kit (Appendix E, Item 1)
EQUlPMENT CONDITION
Lifting device
l Parking brake set (TM 9-2320-272-10).
Rivet gun
Van body sides fully expanded and secured
l
Four chains
(TM 9-2320-272-10).
Hinged roof-operated blackout circuit plungers
l
MATERIALS/PARTS
removed (para. 3-377).
Three cotter pins (Appendix D, Item 56)
l Ceiling rear cover removed (para. 5-80).
Fifty-two rivets (Appendix D, Item 555)
Ceiling filler and side panels removed (para. 5-79).
l
One-hundred fifty-seven rivets (Appendix D,
Left and right side blackout harness removed
l
Item 553)
Seal, 206 in. (Appendix D, Item 633)
SPECIAL ENVIRONMENTAL CONDITIONS
Seal, 206 in. (Appendix D, Item 618)
Seal, 35 in. (Appendix D, Item 621)
Vehicle must be on a level surface.
Seal, 206 in. (Appendix D, Item 622)
GENERAL SAFETY INSTRUCTIONS
Seal, 35 in. (Appendix D, Item 606)
Two cushion pads (left side) (Appendix D,
All personnel must stand clear during lifting
Item 90)
operations.
Two cushion pads (Right side) (Appendix D,
Item 91)
Gasket (Appendix D, Item 232)
O-ring (Appendix D, Item 464)
Twenty-four rivets (Appendix D, Item 554)
Four grommets (Appendix D, Item 251)
Primer (Appendix C, Item 57)
Sealing compound (Appendix C, Item 67)
Adhesive (Appendix C, Item 7)
NOTE
Left and right hinged roofs are maintained the same way. This
procedure covers right side.
1.
Attach four chains to lifting device and hinged roof (1). Remove slack from chains.
2.
Remove four screws (3), two angle brackets (2), and holding rods (4) from hinged roof (1).
5-518
