TM 9-2320-272-24-4
5-75. INTERIOR SIDE PANELS AND LATCHES REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M934/A1/A2
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Parking brake set (TM 9-2320-272-10).
l
MATERIALS/PARTS
Van body sides fully expanded and secured
l
(TM 9-2320-272-10).
Two cotter pins (Appendix D, Item 51)
Gasket (Appendix D, Item 231)
Hinged end panels removed (para. 4-155).
l
Three grommets (Appendix D, Item 251)
Hinged floor removed (para. 5-72).
l
Six lockwashers (Appendix D, Item 364)
Hinged roof removed (para. 5-77).
l
O-ring (Appendix D, Item 479)
Side doors removed (para. 5-70).
l
Four rubber bumpers (Appendix D, Item 563)
SPECIAL ENVIRONMENTAL CONDITIONS
Primer (Appendix C, Item 57)
Sealing compound (Appendix C, Item 67)
Vehicle must be on a level surface.
Adhesive (Appendix C, Item 7)
NOTE
Left and right interior side panels are replaced the same way. This
procedure is for right interior side panel.
Remove six screws (1) and three hooks (2) from side panel frame (3).
1.
Remove six screws (5) and three clips (6) from side panel frame (3).
2.
Remove two screws (8) and striker (7) from side panel frame (3).
3.
Remove two nuts (4), screws (10), lockwashers (11), and door check assembly (9) from door
4.
angle (15). Discard lockwashers (11).
Remove two screws (12), striker (13), and two spacer plates (14) from side panel frame (3).
5.
5-500
