TM 9-2320-272-24-4
5-75. INTERIOR SIDE PANELS AND LATCHES REPLACEMENT (Contd)
Remove eight screws (15) and plate (14) from panel (16).
18.
NOTE
Assistant will help with step 19.
Remove thirty-three screws (13), moldings (27), (28), (29), (12), (17), and (18), and panel (16) from
19.
side panel frame (4).
20.
Remove nut (25) and washer (24) from latch (23).
21.
Remove two screws (7), plate (8), gasket (9), shank (5), and O-ring (6) from latch (23). Discard
O-ring (6) and gasket (9).
22.
Remove two cotter pins (22), pins (20), clevis (26), and clevis (21) from latch (23). Discard cotter pins (22).
Remove four nuts (11), lockwashers (10), and latch (23) from side panel frame (4). Discard
23.
lockwashers (10).
Remove two screws (31) and retainer (30) from side panel frame (4).
24.
Remove clevis (21) from flush bolt (3).
25.
Remove clevis (26) from horizontal bar (19).
26.
Remove horizontal bar (19) and flush bolt (3) from side panel frame (4).
27.
NOTE
Repeat steps 18 through 27 for removal of each front latch
assembly.
Remove screw (1) and grommet (2) from side panel frame (4). Discard grommet (2).
28.
NOTE
Insulate areas of dissimilar metal-to-metal contact with zinc
l
chromate primer.
Apply sealing compound to exterior joints prior to installation.
l
Apply adhesive to rubber and metal surfaces.
l
1.
Install new grommet (2) on side panel frame (4) with screw (1).
2.
Position horizontal bar (19) and flush bolt (3) in side panel frame (4).
3.
Install clevis (26) on horizontal bar (19).
4.
Install clevis (21) on flush bolt (3).
5.
Install retainer (30) on side panel frame (4) with two screws (31).
6.
Install latch (23) on side panel frame (4) with four new lockwashers (10) and nuts (11).
7.
Install clevises (26) and (21) on latch (23) with two pins (20) and new cotter pins (22).
8.
Install new O-ring (6), shank (5), new gasket (9), and plate (8) on latch (23) with two screws (7).
9.
Install washer (24) and nut (25) on shank (5) and latch (23).
NOTE
Insulate entire structure with fibrous glass felt insulation.
l
Assistant will help with step 10.
l
10.
Install panel (16) and moldings (27), (28), (29), (12), (17), and (18) on side panel frame (4) with
thirty-three screws (13).
11.
Install plate (14) on panel (16) with eight screws (15).
NOTE
Repeat steps 2 through 11 for installation of each front latch
assembly.
5-504
