TM 9-2320-272-24-4
45.
Remove snapring (8), speedometer drive gear (7), and woodruff key (4) from intermediate shaft (3).
Discard woodruff key (4) and snapring (8).
46.
Using arbor press, remove intermediate bearing (6), intermediate high-speed gear (5), intermediate
bearing (1), and intermediate low-speed gear (2) from intermediate shaft (3).
47.
Remove companion flange spacer (9) from main input shaft (14).
Using arbor press, remove main input shaft bearing (16), bearing spacer (17), and high-speed
48.
gear (18) from main input shaft (14).
Remove high-speed gear spacer (19) and synchronizer gear (20) from main input shaft (14).
49.
Using arbor press, remove main input shaft bearing (10), bearing spacer (11), low-speed gear (12),
50.
and low-speed gear spacer (13) from main input shaft (14).
For general cleaning instructions, refer to para. 2-14.
1.
2.
For general inspection instructions, refer to para. 2-15.
3.
Inspect two dowel pins (15) of main input shaft (14) for breaks. If broken, replace dowel pins (15).
5-408
