TM 9-2320-272-24-4
5-42. TRANSMISSION OIL PAN AND FILTER MAINTENANCE (Contd)
NOTE
Keep oil pan mounting surface in horizontal position and facing
upward.
Filter suction tube ends are interchangeable.
Insert one end of filter suction tube (3) into new transmission oil filter assembly (2).
1.
Install new O-ring (4) onto opposite end of filter suction tube (3).
2.
Position new transmission oil filter assembly (2) on transmission (6). Ensure filter suction
3.
tube (3) is inserted into oil input port (5).
Install new transmission oil filter assembly (2) on transmission (6) with screw (1). Tighten
4.
screw (1) 10-15 lb-ft (14-20 Nm).
CAUTION
Do not use silicone-type gasket sealing compound when installing
gasket, because oil leakage may result. Oil or light grease coating
may be used to hold gasket in position during installation.
Position new oil pan gasket (10) against housing of transmission (6) and align with holes of
5.
transmission (6).
Position transmission oil pan (7) against oil pan gasket (10) and install with twenty-one screws (9).
6.
Tighten screws (9) finger-tight.
Tighten twenty-one screws (9) 10-15 lb-ft (14-20 Nm) following torque sequence shown.
7.
5-302
