TM 9-2320-272-24-4
5-44. TRANSMISSION CONTROL VALVE REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
EQUIPMENT CONDITION
APPLICABLE MODELS
Low shift valve, low trimmer valve, and modulate
All
lockup valve removed (para. 5-43).
TOOLS
SPECIAL ENVIRONMENTAL CONDITIONS
General mechanic's tool kit (Appendix E, Item 1)
Work area clean and free from blowing dirt and
Torque wrench (Appendix E, Item 146)
dust.
REFERENCES (TM)
TM 9-2320-272-24P
NOTE
Separate and tag screws for installation.
1.
Remove
screw (4) and detent spring and roller (5) from control valve (2).
2.
Remove
three screws (3) from control valve (2).
3.
Remove
screw (1) from control valve (2).
4.
Remove
fifteen screws (6) from control valve (2).
CAUTION
Do not tilt control valve to allow selector valve to drop out.
Selector valve may be damaged.
Remove items as an assembly and do not separate. Loose parts
inside will fall free, resulting in damage to control valve.
5.
Remove control valve (2), separator plate (7), and oil transfer plate (8) from transmission (11).
b. Installation
CAUTION
Do not tilt control valve to allow selector valve to drop out.
Damage to selector valve may result.
1.
Position oil transfer plate (8), separator plate (7), and control valve (2) on transmission (11) so pin
on detent lever (10) aligns with slot on selector valve (9).
2.
Install control valve (2) on transmission (11) with fifteen screws (6). Finger-tighten screws (6).
3.
Install control valve (2) with three screws (3). Finger-tighten screws (3).
4.
Install control valve (2) with screw (1). Finger-tighten screw (1).
5.
Position detent spring and roller (5) on control valve (2) with roller in notch of detent lever (10), and
install with screw (4).
6.
Tighten twenty screws (1), (3), (4), and (6) 9-11 lb-ft (12-15 Nm) in sequence shown.
5-306
