TM 9-2320-272-24-4
5-41. TRANSMISSION TORQUE CONVERTER MAINTENANCE (Contd)
Install spacer (3) on converter turbine hub (4).
16.
Install ball bearing (2) on converter turbine hub (4) until seated against spacer (3).
17.
18.
Install converter turbine (5) in flywheel (1).
19.
Remove stator (6) from converter pump (12).
Remove freewheel roller race (10) and thrust bearing (9) from stator (6).
20.
NOTE
One of three different types of roller springs will be present in
early stators as shown. Either the later or latest type should
be used, but all springs must be of the same type.
The latest type roller springs are installed in a different
manner. The old tab may be either up or down.
Oil-soluble grease will hold springs and rollers in place.
Pack stator cam pockets (17) with oil-soluble grease and install springs (8) and rollers (7) in stator
21.
cam pockets (17).
Apply a small amount of oil-soluble grease to thrust bearing (9) and position thrust bearing (9) to
22.
freewheel roller race (10).
Position freewheel roller race (10) and thrust bearing (9) in stator (6) and turn clockwise until
23.
seated in stator (6).
Position stator (6) on converter turbine (5).
24.
Apply lubricating oil to new seal ring (11) and install on converter pump (12).
25.
Install converter pump (12) on flywheel (1) with thirty new self-locking washers (16) and new self-
26.
locking screws (15). Tighten screws (15) 41-49 lb-ft (56-66 Nm).
NOTE
Hook-type seal ring used on early models.
Install new hook-type seal ring (13) on torque converter pump hub (14).
27.
Install converter retaining strap (19) on torque converter (18) with two screws (20).
28.
5-296
