TM 9-2320-272-24-4
5-41. TRANSMISSION TORQUE CONVERTER MAINTENANCE
THIS TASK COVERS
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning and Inspection
INITIAL SETUP:
APPLICABLE MODELS
MATERIALS/PARTS
All
Converter pump seal ring (Appendix D, Item 636)
Flywheel seal ring (Appendix D, Item 638)
SPECIAL TOOLS
Hook-type seal (Appendix D, Item 637)
Piston seal ring (Appendix D, Item 520)
Bearing puller set (Appendix E. Item 105)
Pump hub gasket (Appendix D, Item 225)
Drive handle (Appendix E, Item 38)
Six lockstraps (Appendix D, Item 342)
Bearing replacer (Appendix E, Item 15)
Thirty self-locking screws (Appendix D, Item 648)
Bushing replacer (Appendix E, Item 25)
Lubricating oil (Appendix C, Item 49)
TOOLS
Oil-soluble grease (Appendix C, Item 53)
Arbor press
REFERENCES (TM)
General mechanic's tool kit (Appendix E, Item 1)
Vernier caliper (Appendix E, Item 159)
TM 9-2320-272-24P
Torque wrench (Appendix E, Item 144)
EQUIPMENT CONDITION
Transmission mounted to holding fixture (para. 5-40).
SPECIAL ENVIRONMENTAL CONDITIONS
Work area clean and free from blowing dirt and
dust.
a. Removal
NOTE
Assistant will help with steps 1 and 2.
1.
Remove four nuts (1), washers (2), and screws (4) from converter retaining strap (3) and
transmission (7).
CAUTION
Torque converter must be pulled straight out of transmission and
not moved from side to side. Side movement will damage hook-
type seal ring on torque converter pump hub.
2.
Pull converter retaining strap (3) with torque converter (5) straight out of transmission (7).
3.
Remove two screws (6) and converter retaining strap (3) from torque converter (5).
5-286
