TM 9-2320-272-24-4
5-40. TRANSMISSION MOUNTING TO HOLDING FIXTURE
THIS TASK COVERS
b. Removal
a. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
TM 9-2320-272-24P
All
EQUIPMENT CONDITION
SPECIAL TOOLS
Transmission removed from vehicle (para. 4-71) or
Holding fixture adapter set (Appendix E,
transmission removed from engine (para. 4-72).
Item 64)
Holding fixture (Appendix E, Item 63)
SPECIAL ENVIRONMENTAL CONDITIONS
Holding fixture base (Appendix E, Item 65)
Work area clean and free from blowing dirt and
TOOLS
dust.
General mechanic's tool kit (Appendix E, Item 1)
GENERAL SAFETY INSTRUCTIONS
Lifting device
Chain
l All personnel must stand clear during lifting
operations.
MATERIALS/PARTS
l Do not remove hoist chain from transmission until
Gasket (Appendix D, Item 224)
transmission is stable. Injury to personnel may
result.
a. Installation
1.
Remove six screws (4), power takeoff cover (3), and gasket (2) from transmission (1). Discard
gasket (2).
2.
Install holding plate (6) and holding fixture (5) on right side of transmission (1) with six washers (7)
and screws (8).
NOTE
Transmission may be mounted on any overhaul stand or holding
fixture. However, the front, rear, and bottom of transmission must
be freely accessible for removal and installation of components.
3.
Install holding fixture base (10) on overhaul stand (11) with four screws (14), washers (13), and
nuts (12).
WARNING
All personnel must stand clear during lifting operations.
l
A snapped cable, or swinging or shifting load, may cause
injury to personnel.
l Do not remove hoist chain from transmission until transmission
is stable on holding fixture base, or injury to personnel may
result.
4.
Using lifting device and chain, lift transmission (1) and holding fixture (5) into position and install
in holding fixture base (10) with pin (15) and setscrew (9).
5.
Remove chain and lifting device from transmission (1)
5-282
