TM 9-2320-272-24-4
5-31. MOUNTING FUEL INJECTION PUMP TO TEST STAND (Contd)
8.
Install rear support bracket (19) and clamp bar (24) on test stand (20) with two washers (16) and
screws (15).
9.
Connect six test stand fuel lines (30) to delivery valve holders (29) and test stand injectors.
10.
Connect air line (32) to manifold pressure compensator (31).
11.
Remove plug (36), two copper washers (35), and adapter (37) from fuel pump (14). Discard copper
washers (35).
12.
Install outlet elbow (34) on fuel pump (14).
13.
Connect test stand supply line (33) to outlet elbow (34).
14.
Remove plug (38) and copper washer (39) from side of fuel pump (14) for access to number one
cylinder. Discard copper washer (39).
15.
Refer to table 5-10, Test Stand Requirements, for further preliminary requirements.
Table 5-10. Test Stand Requirements.
REQUIREMENTS
ITEM
100-108F (38-42C)
Calibration Fluid Temperature
22 psi (152 kPa)
Inlet Pressure
3,000-3,046 psi (20,684-21,001 kPa)
Opening Pressure
1-5-3-6-2-4
Firing Order
1:2
Select Drive Rotation
Clockwise
Direction of Drive Rotation
Six
Number of Injection Cylinders
5-211
