TM 9-2320-272-24-4
5-32. FUEL INJECTION PUMP PRETEST
THIS TASK COVERS:
a. Prestroke and Rack Travel
g. Manifold Pressure Compensator Test
b. Cylinder Phasing (Timing)
h. Start Cut Out Test
I. Fuel Delivery Test
c. High-speed Fuel Delivery Test
j. Fuel Breakaway Test
d. Low-speed Fuel Delivery Test
k. Starting Fuel Delivery Test
e. Rated Speed Test
f. Full Load Delivery
l. Low Idle Fuel Delivery Test
INITIAL SETUP:
MATERIALS/PARTS
APPLICABLE MODELS
Two copper washers (Appendix D, Item 42)
M939A2
REFERENCES (TM)
SPECIAL TOOLS
TM 9-2320-272-24P
Rack extension (Appendix E, Item 112)
TM 9-4910-778-14&P
Plunger lift device (Appendix E, Item 98)
EQUIPMENT CONDITION
TOOLS
Fuel injection pump mounted to test stand (para. 5-31).
General mechanic's tool kit (Appendix E, Item 1)
Dial Indicator (Appendix E, Item 36)
NOTE
Refer to TM 9-4910-778-14&P for operation of fuel injection
pump test stand, DFP 156.
If readings taken during pretest deviate from specifications
listed below, fuel pump must be repaired.
a. Prestroke and Rack Travel
1.
Mount dial indicator (10) and rack travel indicator holder (9) on drive end of fuel pump (13).
Install rack extension (11) on control rack (12).
2.
3.
Pull control lever (2) to full load position and, using rack extension (11), push control rack (12) all
the way back.
4.
Preload dial indicator (10) giving control rack (12) 0.004 in. (0.1 mm) of preload travel.
5.
Install plug (3) in return line access hole (14).
NOTE
Cylinder number one is located at drive end of fuel pump.
Rotate test stand driveshaft until tappet reaches bottom dead
center.
6.
Install plunger lift device (5) on fuel pump (13) with finger of plunger lift device (5) resting on top of
tappet located in cylinder number one.
7.
Mount dial indicator (4) on plunger lift device (5) and zero dial indicator (4).
8.
Manually rotate test stand driveshaft (8) until a reading is observed on dial indicator (4).
Manually reverse rotation test stand driveshaft (8) until dial indicator (4) reads zero.
9.
Apply 435-464 psi (2,999-3,190 kPa) of calibration fluid pressure.
10.
5-214
