TM 9-2320-272-24-3
4-72. TRANSMISSION REPLACEMENT (OUT-OF-VEHICLE)
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
PERSONNEL REQUIRED
Al1
TWO
SPECIAL TOOLS
REFERENCES (TM)
Engine barring tool (Appendix E, Item 8)
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Power plant removed (para. 4-4 or 4-5).
Torque wrench (Appendix E, Item 144)
GENERAL SAFETY INSTRUCTIONS
Transmission jack (Appendix E, Item 147)
l Torque converter must be removed with
MATERIALS/PARTS
transmission.
Gasket (Appendix D, Item 202)
Keep transmission tilted slightly downward.
l
Gasket (Appendix D, Item 203)
Twelve lockwashers (Appendix D, Item 354)
a. Removal
NOTE
l The use of shim stock tube in torque converter access hole
prevents converter screw from falling down behind flywheel. A
loose screw may cause a lockup condition, preventing
crankshaft rotation required to remove remaining screws.
Engine crankshaft may be turned using barring tool.
l
Remove two screws (4), access cover (3), and gasket (2) from flywheel housing (1). Discard gasket (2).
1.
Using engine barring tool, rotate crankshaft until screw (5) is visible in access hole (7).
2.
Roll shim stock (6) into tube form and size to fit diameter of access hole (7). Insert shim stock (6) in
3.
access hole (7) and position over screw (5) against flywheel (9).
Remove remaining twelve screws (5) from flywheel (9) and converter (8) in the same manner,
4.
Remove four screws (13), lockwashers (12), and clamp (11) from 9, 11, 1, and 3 o'clock positions on
5.
flywheel housing (1) and transmission (10). Discard lockwashers (12).
4-476
