TM 9-2320-272-24-2
4-32. ENGINE INJECTOR TIMING INSTRUCTIONS (Contd)
NOTE
. Ensure push tubes remain seated during rocker lever housing
installation.
. Rocker lever housings are mounted with screw-assembled
washers on late model engines.
Loosen eighteen screws (9) on three rocker lever housings (6).
2.
Position three new gaskets (8) and rocker lever housings (6) on cylinder heads (7) and install with
3.
twelve washers (5) and screws (4). Do not tighten screws (4).
Install two lifting eyes (3) and upper radiator support bracket (1) on rocker lever housings (6) with
4.
six screws (2). Tighten screws (2) and (4) 55-65 lb-ft (75-88 Nm) in sequence shown.
k. Rocker Lever Housing Covers Installation
NOTE
l Rocker lever housing covers are mounted with screw-assembled
washers on late model engines.
l All rocker lever covers are installed the same way. This task
covers the installation of the center housing cover.
Install new housing cover gasket (13) and rocker lever housing cover (12) on rocker lever housing (6) with
five washers (11) and screws (10).
4-246
