TM 9-2320-272-24-2
NOTE
Assistant will push A-frame toward cab during steps 10 and 11.
On M932/A1/A2 vehicles, cable is passed directly over rear
crossmember and attached to pintle hook because vehicle is not
equipped with eyebolt assembly.
10.
Thread cable (3) through eyebolt (4) and install cable (3) on pintle hook (5).
11.
Install shackle (7) on cable (3) and harness (9) with shackle pin (8).
NOTE
A-frame must be angled approximately 60 degrees from horizontal.
Do not insert setscrews until adjustment is made.
12.
Loosen clamp (6) at cut end of cable (3) and position A-frame legs (10) at an angle of approximately
60 degrees from horizontal. Tighten clamp (6).
13.
Install setscrew (11) on each A-frame leg (10) and bracket (12). Tighten setscrew (11) until cable (3)
slack is taken up.
14.
Install snatch block (2) on A-frame spreader tube (1).
NOTE
Do not perform follow-on tasks if A-frame kit has been installed.
3-1050