TM 9-2320-272-24-2
THIS TASK COVERS:
a. Removal
c. Installation
b. Inspection
INITIAL SETUP:
APPLICABLE MODELS
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-272-10).
M925/A1/A2, M928/A1/A2, M932/A1/A2
Cab tarpaulin removed (task c. only)
TOOLS
(TM 9-2320-272-10).
General mechanic's tool kit (Appendix E, Item 1)
Windshield lowered (task c. only)
(TM 9-2320-272-10).
MATERIALS/PARTS
Tailgate removed (except M932/A1/A2)
Lockwasher (Appendix D, Item 416)
(task c. only) (para. 3-343).
Front lifting shackles removed (task c. only)
PERSONNEL REQUIRED
TWO
GENERAL SAFETY INSTRUCTION
REFERENCES (TM)
Do not perform this procedure near high-voltage wires.
TM 9-2320-272-10
TM 9-2320-272-24P
Do not perform this procedure near high-voltage wires. Vehicle
will become charged with electricity if A-frame contacts or breaks
high-voltage wire. Do not leave vehicle while high-voltage line is
in contact with A-frame or vehicle. Failure to comply may result in
injury to personnel.
1.
Remove
snatch block (2) from A-frame spreader tube (1).
2.
Remove
setscrew (10) from each A-frame leg (9) and bracket (11).
NOTE
Assistant will push A-frame toward cab during steps 3 and 4.
3.
Remove
shackle pin (7) from shackle (6) and separate cable (3) and harness (8) from shackle (6).
4.
Remove
cable (3) from pintle hook (5) and eyebolt (4).
3-1046
