TM 9-2320-272-24-2
3-301. FENDER SPLASH SHIELD REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-272-10
All
TM 9-2320-272-24P
TOOLS
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMENT CONDITION
l Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
l Fender extension removed (para. 3-300).
l Air cleaner intake pipe hump hose removed
Four locknuts (Appendix D, Item 291)
(para. 3-13).
Three lockwashers (Appendix D. Item 358)
NOTE
Fender splash shield replacement is the same for both left and
right side. This procedure covers the right fender splash shield.
a. Removal
1.
Remove locknut (8), screw (6), and washer (7) from splash shield (5) and support brace (11). Discard
locknut (8).
2.
Remove three screws (9) and lockwashers (10) from splash shield (5) and cab extension (12). Discard
lockwashers (11).
3.
Remove three locknuts (4), washers (3), and splash shield (5) from screws (2) and cab floor (1).
Discard locknuts (4).
b. Installation
1.
Install splash shield (5) on cab floor (1) and three screws (2) with three washers (3) and new
locknuts (4).
2.
Install splash shield (5) on cab extension (12) with three new lockwashers (10) and screws (9).
3.
Install splash shield (5) on support brace (11) with washer (7), screw (6), and new locknut (8).
FOLLOW-ON TASKS: l Install air cleaner intake pipe hump hose (para. 3-13).
Install fender extension (para. 3-300).
l
3-795
