TM 9-2320-260-34-2
16-41. TRANSMISSION POWER TAKEOFF REPAIR (Contd)
Install two bearings (9) in input gear (10). Seat bearings (9) slightly below end faces of input
39.
gear (10).
NOTE
Front end of pin is slightly larger than the other and has a slot
q
in the rear end to aid in pin groove alinement.
q Mark front of pin to indicate groove position.
40.
Start input gear pin (5) in front bore (6) of PTO housing (l), small end first.
Place thrust washer (8), input gear (10), and second thrust washer (8) over input gear pin (5).
41.
Work through opening (7). Large end of input gear (10) is toward front of PTO housing (1).
Turn input gear pin (5) and push back and forth until cotter pin groove (4) of input gear pin (5)
42.
alines with cotter pin hole (3) in PTO housing (1).
43.
Install new cotter pin (2) in PTO housing (1) and input gear pin (5).
44.
Install two new seals (11) and (12) in two bores (17) of PTO housing (1).
45.
Push shift pin (13), threaded end first, through seal (12) in rear of PTO housing (1).
46.
Place lug end of shift fork (15) in slot in gear (16) and push shift pin (13) through bore of shift
fork (15) and continue to push shift pin (13) through front seal (11) in bore (17).
47.
Turn shift pin (13) to aline groove (14) with screw hole in shift fork (15) and install screw (22) in
shift. fork (15) and groove (14) of shift pin (13).
48.
Retain screw (22) to shift fork (15) with new safety wire (23). Bend twisted ends of safety wire (23)
around shift fork (15) to clear gear (16).
49.
Place ball bearing (20) and spring (19) in bore (21) and install with retainer (18).
Install new gasket (24) and cover (25) on PTO housing (1) with six new lockwashers (26) and
50.
screws (27).
Position boot (31) over front end of shift pin (13) and install into PTO housing (1) with new
51.
retainer (30).
Install washer (29) and screw (28) on shift pin (13).
52.
Position boot (32) over rear end of shift pin (13) and install on PTO housing (1) with new
53.
retainer (33).
16-248
