TM 9-2320-260-34-2
16-41. TRANSMISSION POWER TAKEOFF REPAIR (Contd)
NOTE
Perform steps 17 through 35 for dual output shaft PTO.
Install snapring (4) in rear groove of cover (3).
17.
18.
Using arbor press and adapter, install bearing (5) in cover (3). Seat bearing (5) against snapring (4).
19.
Install snapring (2) in front groove of cover (3).
NOTE
Support inner race of bearing during rear output shaft installation.
20.
Using arbor press, install rear output shaft (6), threaded end first, in and through bearing (5). Seat
shoulder of rear output shaft (6) to inner race of bearing (5).
21.
Install snapring (7) in groove on rear output shaft (6).
22.
Install new seal (8) in rear of cover (3).
23.
Install new seal (9) in rear pin bore ( 10) of cover (3).
24.
Slide clutch gear (1) onto splines of rear output shaft (6).
25.
Position shift fork (13) over groove in rear output shift pin (14) and insert rear output shift pin (14)
through bore of shift fork (13). Insert rear output shift pin (14) through rear shift pin bore ( 10) and
seal (9). Threaded end (15) of rear output shift pin (14) goes into bore. Do not put end of rear
output shift pin (14) with side hole (16) in first.
26.
Aline side hole (16) in rear output shift pin (14) with threaded hole in shift fork (13), and install shift
fork (13) on rear output shift pin (14) with screw (12),
27.
Install new safety wire (11) in screw (12) and wrap around shift fork ( 13). Twist ends of safety
wire (11) together and bend twist around shift fork (13).
28.
Place ball (25) and spring (24) in bore (22) and retain with plug (23).
29.
Place boot (17) over rear output shift pin (14) and install boot (17) to cover (3) with new
retainer (21).
30.
Thread jamnut (18) on eyebolt (19) if it was removed.
31.
Place washer (20) over rear output shift pin (14) and install boot (17) to rear output shift pin (14)
with eyebolt (19). Tighten jamnut (18) against washer (20).
16-246
