TM 9-2320-260-34-2
16-8. REAR WINCH REPAIR (Contd)
25.
Place thrust washer (5) over shaft (4) against gearcase (1). Ensure thrust washer (5) key engages
key in thrust washer (2).
26.
Install two new keys (3) in shaft (4).
27.
Install new seal (6) in gearcase end of drum (7).
28.
Place drum (7) on shaft (4) and aline keyways in drum (7) to keys (3) in shaft (4). Position drum (7)
against thrust washer (5) and gearcase (1).
29.
Position thrust washer (8) over shaft (4) against drum (7) with key of thrust washer (8) facing away
from drum (7).
30.
Aline end of shaft (4) to sleeve and bushing (10) and place end frame (9) on shaft (4) against
drum (7). Ensure key of thrust washer (8) engages notch in end frame (9).
31.
Install channel (11) on gearcase (1) and end frame (9) with three new lockwashers (12), three
screws (13), screw (16), new lockwasher (15), and nut (14).
Install grease fitting (17) in end frame (9).
32.
16-56
