TM 9-2320-260-34-2
16-3. FRONT WINCH LEVEL WIND MAINTENANCE (Contd)
NOTE
Both sets of winch trolley wheels are installed the same.
Pack bearing (7) with grease and place in trolley wheel (6),
20.
21.
Soak two new felt washers (5) in lubricating oil and place one on each end of bearing (7).
Place two washers (4) in trolley wheel (6) over each felt washer (5).
22.
Place trolley wheel (6) on axle (8).
23.
NOTE
Install hollow screws on same side of level wind assembly that
faces front of winch.
Install new lockwasher (3) and hollow screw (2) or solid screw (9) on end of axle (8) that faces front
24.
of winch.
Install grease fitting (1) in hollow screw (2).
25.
Install poppet (13) and spring (18) on track frame (24) with poppet nut (19).
26.
Install latch (20) on poppet (13) with two nuts (21).
27.
Install two jamnuts (12) on stop screws (11) to recorded position.
28.
Insert stop screws (11) through end plates of track frame (24) and install with two nuts (16).
29.
NOTE
Roll level wind back and forth as needed to allow access to screw
holes through rectangular slots in track frame.
Position level wind (10) on track frame (24) and install with four new lockwashers (23) and
30.
screws (22). Ensure level wind (10) travels freely on tracks of track frame (24) and poppet (13)
engages and holds level wind (10) in locked position.
Install track frame (24) with level wind (10) on front winch (17) with four new lockwashers (15) and
screws (14).
16-26
