TM 9-2320-260-34-2
15-88. OUTLET BOX REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
M820, M820A2
TM 9-2320-260-20
TEST EQUIPMENT
TM 9-2320-260-34P-2
Multimeter (Appendix B, Item 115)
EQUIPMENT CONDITION
TOOLS
q External power source disconnected
(TM 9-2320-260-10).
General mechanic's tool kit
q Battery ground cable disconnected
(Appendix B, Item 1)
Tool kit, electrical (Appendix B, Item 106)
(TM 9-2320-260-20).
Soldering gun (Appendix B, Item 117)
MATERIALS/PARTS
Gasket (Appendix D, Item 76)
Four locknuts (Appendix D, Item 182)
Solder (Appendix C, Item 47)
NOTE
Tag wires, cables, and leads for installation.
1. Disconnect auxiliary pump wiring harness (1) from connector (2).
2. Remove four screws (3), cover (4), and gasket (5) from outlet box (6). Discard gasket (5).
3. Desolder three wires (8) from connector (2).
4. Remove four locknuts (12), screws (13), and connector (2) from cover (4). Discard locknuts (12).
5. Remove nut (11) from conduit (9) and outlet box (6).
6. Remove two screws (10) and outlet box (6) from van body (7).
1. Slide outlet box (6) onto end of conduit (9), secure outlet box (6) to conduit (9) with nut (11), and
route wires (8) through hole in outlet box (6).
2. Install connector (2) on cover (4) with four screws (13) and new locknuts (12).
3. Position new gasket (5) and cover (4) on outlet box (6) and solder three wires (8) on connector (2).
4. Install new gasket (5) and cover (4) on outlet box (6) with four screws (3).
5. Install auxiliary pump wiring harness (1) on connector (2).
15-328
