TM 9-2320-260-34-2
I5-38. CEILING REGISTERS AND DEFLECTORS REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
EQUIPMENT CONDITION
APPUCABLE MODELS
Parking brake set (TM 9-2320-260-10).
M820, M820A1, M820A2
GENERAL SAFETY INSTRUCTIONS
TOOIS
Gloves, eyeshields, and dust mask must be worn
General mechanic's tool kit
during register and deflector replacement.
(Appendix B, Item 1)
REFERENCES (TM]
TM 9-2320-260-10
TM 9-2320-260-34P-2
WARNING
Van body is insulated with fibrous glass felt insulation. Gloves,
eyeshields, and dust mask must be worn during register and
deflector replacement. Failure to do so may result in injury to
personnel.
NOTE
All ceiling registers and cleflectors are replaced the same. This
q
procedure covers the replacement of one register and deflector,
Registers and deflectors in M820, M820A1, and M820A2 vehicles
q
are replaced the same. This procedure covers the M820 and
M820A2 vehicles.
a. Removal
1. Remove two screws (5) and register (6) from ceiling side panel (4) and deflector (2).
2. Remove twelve screws (1) and deflector (2) from air duct (3) and ceiling side panel (4).
3. Remove two screws (8) and register (7) from air duct (3).
1. Install register (7) on air duct (3) with two screws (8).
2. Install deflector (2) on air duct (3) and ceiling side panel (4) with twelve screws ( 1).
3. Install register (6) on ceiling side panel (4) and deflector (2) with two screws (5).
15-154
