TM 9-2320-260-34-2
15-36. CEILING AND FRAME MAINTENANCE
THIS TASK COVERS:
c. Installation
a. Removal
b. Cleaning and Inspection
INITIAL SETUP
APPLICABLE MODELS
MATERIALS/PARTS (Contd)
M820, M820A1, M820A2
Fibrous glass felt insulation (Appendix C, Item 16)
Adhesive (Appendix C, Item 2)
TOOLS
Primer (Appendix C, Item 31)
General mechanic's tool kit
REFERENCES (TM)
(Appendix B, Item 1)
TM 9-2320-260-10
Rivet gun (Appendix B, Item 120)
TM 9-2320-260-34P-2
MATERIALS/PARTS
EQUIPMENT CONDITION
One hundred two rivets
q Parking brake set (TM 9-2320-26 0-10).
q Van body sides fully expanded and secured
Ninety-three rivets (Appendix D, Item 357)
Six lockwashers (Appendix D, Item 219)
(TM 9-2320-260-10).
Ceiling air ducts removed (para. 15-45).
Seal (Appendix D, Item 454)
q Ceiling transition removed (para. 15-42 or 15-43).
Eighty-two rivets (Appendix D, Item 346)
q Rear doors removed (para. 15-28).
One hundred twenty-four rivets
GENERAL SAFETY INSTRUCTIONS
One hundred forty-four rivets
Gloves, eyeshields, and dust mask must be worn
during ceiling replacement.
Ninety-three rivets (Appendix D, Item 353)
Two seals (Appendix D, Item 453)
WARNING
Van body is insulated with fibrous glass felt insulation. Gloves,
eyeshields, and dust mask must be worn during ceiling replace-
ment. Failure to do so may result in injury to personnel.
NOTE
Assistant will help with steps 1 through 4.
1. Remove ninety-three rivets (4), ceiling panel (3), and two liner strips (1) from ceiling frame (2).
Discard rivets (4).
2. Remove one hundred two rivets (5), ceiling panel (6), and two liner strips (1) from ceiling frame (2).
15-131
