TM 9-2320-260-34-2
15-28. REAR DOORS MAINTENANCE
THIS TASK COVERS:
d. Assembly
a. Removal
e. Installation
b. Disassembly
c. Cleaning and Inspection
INITIAL SETUP
MATERIALS/PARTS (contd)
APPLICABLE MODELS
Seal (M820, M820A2) (Appendix D, Item 448)
M820, M820A1, M820A2
Seal (M820A1) (Armendix D, Item 446)
TOOLS
Weatherseal (Ieft-rear, M820, M820A1)
General mechanic's tool kit
Weatherseal (left-rear, M820A2)
(Appendix B, Item 1)
Rivet gun (Appendix B, Item 120)
Sealing compound (Appendix C, Item 45)
MATERIALS/PARTS
Adhesive (Appendix C, Item 3)
Two cotter pins (Appendix D, Item 21)
REFERENCES (TM)
Four lockwashers (M820, M820A1)
TB 43-0213
Two lockwashers (right-rear, M820A1)
TM 9-2320-260-10
TM 9-2320-260-20
Two lockwashers (Appendix D, Item 223)
TM 9-2320-260-34P-2
Four locknuts (M820, M820A1)
EQUIPMENT CONDITION
Ladders removed (TM 9-2320-260-10).
Seven rivets (Appendix D, Item 346)
Three rivets (right-rear)
Liftgate lowered (M820A2) (TM 9-2320-260-10).
Door window removed (if equipped)
Gasket (right-rear) (Appendix D, Item 78)
(M820, M820A2) (TM 9-2320-260-20).
Seal (Appendix D, Item 444)
Seal (Appendix D, Item 445)
a. Removal
NOTE
Left- and right-rear doors are removed the same. This procedure
covers the left-rear door.
1.
Remove two screws (1), lockwashers (2), doorcheck (3), and bracket (4) from door (7). Discard
lockwashers (2).
2. Remove fifteen screws (6) and door (7) from van body (5).
b. Disassembly
I
NOTE
Perform steps 1 through 3 for M820 and M820A1 vehicles.
1.
Remove four screws (10) and two angle brackets (9) from outer panel of door (7).
2.
Remove four screws (13), lockwashers (12), and clamp (11) from outer panel of door (7). Discard
lockwashers (12).
3. Remove two screws (15), locknuts (14), screws (8), washers (18), bushings (17), and rack (16) from
outer panel of door (7). Discard locknuts (14).
15-86
