TM 9-2320-260-34-2
15-35. INTERIOR SIDE PANELS AND LATCHES REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
MATERIALS/PARTS (Contd)
APPLICABLE MODELS
M820, M820A1, M820A2
Adhesive (Appendix C, Item 2)
Fibrous glass felt insulation (Appendix C, Item 16)
TOOLS
REFERENCES (TM)
General mechanic's tool kit
(Appendix B, Item 1)
TM 9-2320-260-10
TM 9-2320 -260-34P-2
MATERIALS/PARTS
EQUIPMENT CONDITION
Four cotter pins (Appendix D, Item 43)
Two gaskets (Appendix D, Item 104)
q Parking brake set (TM 9-2320-260-10).
q Van body sides fully expanded and secured
Eight lockwashers (Appendix D, Item 247)
(TM 9-2320-260-10).
Two lockwashers (Appendix D, Item 224)
Four locknuts (Appendix D, Item 196)
q Hinged end panels removed (para. 15-33).
Two O-rings (M820, M820A2)
Hinged floor removed (para. 15-31).
q Hinged roof removed (para. 15-37).
q Side doors removed (para. 15-29).
Three rubber bumpers (Appendix D, Item 369)
GENERAL SAFETY INSTRUCTIONS
Four rubber bumpers (Appendix D, Item 368)
Gloves, eyeshields, and dust mask must be worn
Primer (Appendix C, Item 31)
during panel replacement.
Sealing compound (Appendix C, Item 43)
WARNING
Van body is insulated with fibrous glass felt insulation. Gloves,
eyeshields, and dust mask must be worn during panel replace-
ment. Failure to do so may result in injury to personnel.
NOTE
Left and right interior side panels are removed the same. This
procedure covers the right interior side panel.
1. Remove six screws (1) and three hooks (2) from side panel frame (4).
2. Remove six screws (7) and three clips (3) from side panel frame (4).
3. Remove two screws (8) and striker (9) from side panel frame (4).
4. Remove two screws (11), Iockwashers (12), nuts (5), and door check (10) from door angle (6). Discard
Iockwashers (12).
5. Remove two screws (13), striker (14), and two spacer plates (15) from side panel frame (4).
15-120
