TM 9-2320-260-34-2
15-31. HINGED FLOOR MAINTENANCE
THIS TASK COVERS:
d. Assembly
a. Removal
e. Installation
b. Disassembly
c. Cleaning and Inspection
INITIAL SETUP
MATERlALS/PARTS (Contd)
APPLICABLE MODEM
Adhesive (Appendix C, Item 2)
M 8 2 0 , M820A1, M820A2.
sealing compound (Appendix C, Item 45)
TOOLS
REFERENCES (TM)
General mechanic's tool kit
TM 9-237
(Appendix B, Item 1)
TM 9-2320-260-10
Rivet gun (Appendix B, Item 120)
TM 9-2320-260-20
MATERIALS/PARTS
TM 9-2320 -260-34P-2
Four seals (M820, M820A2)
EQUIPMENT CONDITION
Four seals (M820A1) (Appendix D, Item 444)
l Van body sides fully expanded and secured
Seal (Appendix D, Item 449)
(TM 9-2320-260-10).
l Hinged end panel opened (TM 9-2320-260-10),
Fifty-six rivets (Appendix D, Item 351)
l Counterbalance removed (TM 9-2320-260-20).
NOTE
Left and right side hinged floors are maintained the same. This
procedure covers the left hinged floor.
NOTE
Perform step 1 for M820 and M820A2 vehicles.
Perform step 2 for M820A1 vehicles.
Assistant will help with step 1 or 2.
1. Remove fifty-five screws (4), four screws (2), and hinged floor (1) from hinge (3).
2. Remove fifty-nine screws (4) and hinged floor (1) from hinge (3).
NOTE
Perform step 1 for M820 and M820A2 vehicles.
1. Remove four screws (7) and two pivots (8) from hinged floor (1).
2. Remove thirty screws (9), two retainers (6), four seals (10), and two channels (5) from hinged
floor (1). Discard seals (10).
3. Remove ten screws (13) and five pads (12) from hinged floor ( 1).
4. Remove four screws (15) and handle (14) from hinged floor (1).
5. Remove seal (11) from hinged floor (l). Discard seal (11).
NOTE
Perform step 6. if hinge is to be replaced (subtask c.).
6. Remove fifty-six rivets (16) and hinge (3) from underframe (17). Discard rivets (16).
15-102
