TM 9-2320-260-34-2
15-34. REAR WALL INTERIOR PANELS REPLACEMENT
THIS TASK COVERS:
b. Left Panel Installation
a. Left Panel Removal
INITIAL SETUP
EQUIPMENT CONDITION (Contd)
APPLICABLE MODELS
q Load center conduit removed
M820, M820A1, M820A2
(M820, M820A2) (left side) (para. 15-83).
TOOLS
q Electrical box removed (M820, M820A2) (left side)
General mechanic's tool kit
(Appendix B, Item 1)
q Control center box removed (M820, M820A2)
(right side) (para. 15-84).
MATERIALS/PARTS
AC manual starter switches removed
Sealing compound (Appendix C, Item 45)
(M820, M820A2) (right side) (para. 15-89).
q Phone jacks removed (M820, M820A2)
REFERENCES (TM)
(right side) (TM 9-2320-260-20).
TM 9-2320-260-10
Fire extinguisher removed (right side)
TM 9-2320-260-20
(TM 9-2320-260-10).
TM 9-2320 -260-34P-2
GENERAL SAFETY INSTRUCTIONS
EQUIPMENT CONDITION
Gloves, eyeshields, and dust mask must be worn
q Van body sides fully expanded and secured
during panel replacement.
(TM 9-2320-260- 10).
q Load center removed (M820, M820A2)
(left side) (para. 15-82).
Van body is insulated with fibrous glass felt insulation. Gloves,
eyeshields, and dust mask must be worn during panel replace-
ment. Failure to do so may result in injury to personnel.
NOTE
Left- and right-rear wall interior panels are replaced the same.
This procedure covers the left-rear wall interior panel.
1. Remove thirteen screws (4) and molding (1) from left panel (2) and header (3).
NOTE
Assistant will help with step 2.
2. Remove twenty-two screws (5) and left panel (2) from header (3).
3. Remove four screws (8) and corner gusset (7) from skin (6) and underframe (9).
NOTE
Apply sealing compound to exterior joints for installation.
1.
Install corner gusset (7) on skin (6) and underframe (9) with four screws (8).
NOTE
Assistant will help with step 2.
2. Install Ieft panel (2) on header (3) with twenty-two screws (5).
3. Install molding (1) on left panel (2) and header (3) with thirteen screws (4).
15-118
