TM 9-2320-260-34-2
15-12. CAB PROTECTOR SHIELD MAINTENANCE (Contd)
I
b. Cleaning and Inspection
1. For general cleaning instructions, refer to para. 2-8.
2. Inspect cab protector shield (1) for cracks, breaks, and broken welds. Repair broken welds, cracks,
and breaks (TM 9-237).
1.
Install two screws (2), four washers (3), two nuts (4), and chain on cab protector shield (1).
Attach lifting device to chain.
2.
WARNING
All personnel must stand clear during lifting operations.
q
A swinging or shifting load may cause injury to personnel.
Ensure lifting capacity is greater than weight (465 lb (211 kg))
q
of cab protector shield. Failure to do so may result in injury to
personnel or damage to equipment,
NOTE
Assistant will help with step 3.
3.
Raise cab protector shield (1) away from supports and lower onto dump body (11).
NOTE
Ensure holes of cab protector shield aline with holes of dump body.
4.
Install cab protector shield (1) on dump body (11) with four screws (13), washers (12), and new
locknuts (7).
Install cab protector shield (1) on dump body (11) with four washers (6), screws (5), washers (8),
5.
nuts (9), and new cotter pins (10).
Install cab protector shield (1) on dump body (11) with eight washers (15), screws (16), and new
6.
locknuts (14).
7.
Remove lifting device from chain.
8.
Remove two nuts (4), screws (2), washers (3) and chain from cab protector shield (1).
15-26