TM 9-2320-260-34-2
15-2. CARGO BODY REPLACEMENT (Contd)
b. Installation
1.
Install two guide lines and chains to cargo body (1).
Install lifting device to two chains.
2.
WARNING
All personnel must stand clear during lifting operations.
A swinging or shifiing load may cause injury to personnel.
Z Ensure lifting capacity is greater than weight (1,800 lb (817 kg))
of cargo body. Failure to do so may result in injury to personnel
or damage to equipment.
NOTE
Use breaker bar to aline body and frame brackets.
q
Two assistants will help with step 3.
q
3.
Raise cargo body (1) away from supports and position on frame (2).
Install four screws (3), washers (7), springs (8), springs (9), washers (7), and new locknuts (6) on two
4.
brackets (4) and brackets (5).
Tighten locknuts (6) to set springs (8) and (9) height to 6.375 in. (16.19 cm).
5.
NOTE
Perform step 6 for M813 and M813A1 vehicles.
q
Perform step 7 for M814 vehicles.
q
Install four screws (15) and new locknuts (18) on four brackets (16) and (17). Tighten locknut ( 18)
6.
40-50 lb-ft (54-68 Nm).
Install twelve screws (19) and new locknuts (22) on six brackets (20) and (21). Tighten locknuts
7.
(227) 40-50 lb-ft (54-68 Nm).
Remove lifting device from two chains.
8.
Remove two guide lines and chains from cargo body (1).
9.
NOTE
Steps 10 and 11 describe one side only. Perform steps 10 and 11 for
both sides of cargo body.
10.
Install two clips (11) on cargo body (1) with two screws (14) and new locknuts ( 10).
11.
Connect wiring harness (13) to four wires (12).
15-4
