TM 9-2320-260-34-2
15-2. CARGO BODY REPLACEMENT (Contd)
NOTE
Step 1 describes one side only. Perform step 1 for both sides of
cargo body.
1. Disconnect four wires (4) from wiring harness (5) and remove two screws (6), clips (2), and
locknuts (1) from cargo body (3). Discard locknuts (l).
2. Attach chains around cargo body (3).
WARNING
All personnel must stand clear during lifting operations.
q
A swinging or shifting load may cause injury to personnel.
q Ensure lifting capacity is greater than weight (1,800 lb (817 kg))
of cargo body, Failure to do so may result in injury to personnel
or damage to equipment.
3. Attach chains to lifting device and remove slack from chains.
4. Attach two guide lines to cargo body (3).
5. Remove four locknuts (11), washers (12), springs (13), springs (14), washers (12), and screws (8) from
two brackets (9) and brackets (10). Discard locknuts (11).
NOTE
q Perform step 6 for M814 vehicles.
Z Perform step 7 for M813 and M813A1 vehicles.
6. Remove twelve locknuts (22) and screws ( 19) from six brackets (20) and (21). Discard locknuts (22),
7. Remove four locknuts (18) and screws (15) from four brackets (16) and (17). Discard locknuts (18).
NOTE
Two assistants will help with step 8.
8. Raise cargo body (3) away from frame (7) and lower on supports.
9. Remove lifting device from two chains.
10. Remove two chains and guide lines from cargo body (3).
15-2
