TM 9-2320-260-34-1
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
MATERIAIS/PARTS (Contd)
M816, M819
O-ring (Appendix D, Item 288)
Two lockwashers (Appendix D, Item 233)
TOOLS
O-ring (Appendix D, Item 276)
General mechanic's tool kit
REFERENCES (TM)
(Appendix B, Item 1)
TM 9-2320-260-34P-1
MATERIALS/PARTS
EQUIPMENT CONDITION
Filter kit (Appendix D, Item 335)
Gasket (Appendix D, Item 124)
Seal (Appendix D, Item 424)
Seal (Appendix D, Item 426)
Remove two screws (4), lockwashers (3), washers (2), shutoff valve (5), and O-ring (6) from
1.
2.
Remove filter cap (1), gasket (17), spring (16), filter (15), O-ring (14), retainer (13), and filter
screen (12) from fuel pump (9) and governor (7). Discard filter cap (1), gasket (17), spring (16),
filter (15), O-ring (14), retainer (13), and filter screen (12).
3.
Remove spring (11) from throttle lever (8) and bracket (10).
4.
Remove screw (18), seal (26), governor (7), and seal (22) from fuel pump (9). Discard seals (22)
and (26).
NOTE
Perform step 5 if adapter is damaged.
5.
Remove adapter (23), gasket (24), and O-ring (25) from governor (7). Discard gasket (24) and
O-ring (25).
NOTE
Mark throttle lever positions for installation.
Loosen two nuts (19), screws (21) and remove throttle levers (8) and (20) from governor (7).
6.