TM 9-2320-260-34-1
THIS TASK COVERS:
Installation
INITIAL SETUP
MATERIALS/PARTS
APPLICABI.E MODELS
Gasket (Appendix D, Item 111)
All
Twenty-eight screw-assembled lockwashers
TOOLS
(Appendix D, Item 395)
General mechanic's tool kit
Eight lockwashers (Appendix D, Item 217)
(Appendix B, Item 1)
Sealing compound (Appendix C, Item 43)
REFERENCES (TM)
(Appendix B, Item 4)
TM 9-2320-260-20
TM 9-2320-260-34P-1
1. Apply sealing compound to oil pan (17) and install new gasket (10) on oil pan (17).
2. Install oil pan (17) and two clamps (19) on cylinder block (15) with twenty-eight new screw-
assembled lockwashers (18). Finger tighten screw-assembled lockwashers (18).
3. Install four washers (3), new lockwashers (2), and screws (1) on rear of oil pan (17). Finger tighten
screws (l).
4. Install four washers (8), new lockwashers (7), and screws (6) on cylinder block (15). Finger tighten
screws (6).
5. Install four screws (4) on oil pan (17) and flywheel housing (16).
CAUTION
Tighten oil pan screws evenly, starting from middle of each side of
pan. Failure to do so may result in warpage of oil pan flange.
6. Alternately tighten screw-assembled lockwashers (18) 35-40 lb-ft (47-54
7. Alternately tighten screws (1) and (6) 15-40 lb-ft (20-54
8. Install front sump tube (11) on scavenger adapter (9).
9. Install oil pickup hose (13) on suction flange (5).
10. Install oil return hose (14) on aerator (12).